Panasonic Omnivision PV-9400 User Manual

Before Using
Basic Connection
Congratulations
on your purchase of one of the most.sophisticated and
reliable products on the market today. Used property,
it will bring you and your family years of enjoyment.
Please fill in the information below. The serial number
is on the tag located on the back of your VCR.
¢ Date of Purchase
¢ Dealer Purchased From
¢ Dealer Address
¢ Dealer Phone No.
* Model No.
¢ Serial No.
fVorel-s-S-10) g(=5-)
CJ Remote Control LJ Batteries 2 “AA”
VSQS1597 (PV-9400)
VSQS1596 (PV-9450)
CJ] RF Coaxial Cable
VJAS0196
| Model PV-9450
remote is
| shown here.
To order accessories, call toll free
1-800-332-5368.
Wor-Tol late Mm tatom =f: 100-1 a(-t
1) Open the cover.
2) Insert the
batteries as
marked.
(_] Battery replacement caution
* Do not mix old and new batteries.
* Do not mix alkaline with manganese batteries.
4
3) Close the cover.
ANTE N NA (See page 5)
CABLE TV
aw.
am,
*:
Disconnect antenna
or cable from TV and
connect to VCR.
VCR
IN FROM/ ANT
OUT TO TV
3 ch 4
channel 3 or 4 (not
an active station).
2
Connect VCR
to TV with RF
Coaxial Cable.].
C Set VCR Output to
“VHF/UHF
Tune TV to VCR output channel
the same one you Set in step 3.
WARNING
When using “Nut type” RF coaxial cables, tighten with
fingers only. Overtightening may damage terminals.
For assistance, call 1-800-211-PANA(7262).
OUTDOOR ANTENNA INDOOR ANTENNA |
L

Panasonic Omnivision PV-9400 Specifications

General

Brand	Panasonic
Model	Omnivision PV-9400
Category	VCR
Language	English