Panasonic Omnivision PV-9450

[A check list before you begin.
C0) VCR is connected to a stereo TV, or a mono TV and an externa!
stereo amp or receiver with speakers.
(C2) VCR and other components are plugged in and turned on.
Connections to Make
VIDEO O T
LO o AMP
AUDIO R
| A
O
|
OTO
O
AUDIQ
To monitor recording in progress in stereo,
connect VCR to stereo TV or mono TV and ;
stereo amp with speakers, —OEee—OE _|
Receivable Broadcast Types
The following are possible audio broadcast types and on-screen displays.
The signal being received is indicated with an “{@” mark while the selected
audio mode is indicated with an arrow.
Display the broadcast signal being received.
DISPLAY | Press DISPLAY.”
MTS Stereo and SAP broadcast STOP
Multi-channel Television Sound Stereo
(main language) and Secondary Audio
Program (sub language) broadcasts are
both being received simultaneously.
Select STEREO or SAP audio mode.
12:00AM ABC
0:00:00
ce 4
MTS Stereo broadcast STOP 12:00AM , noe
Multi-channel Television Sound Stereo (STEREO « SP
broadcast. Select STEREO audio mode. SAP
* If stereo broadcast is weak and display MONO
flickers, select MONO audio mode for
possibly better results.
DISPLAY
SAP
broadcast
BPRS
TEL
GOAM
aan
Secondary
Audio
Program
(sub
language)
aa
broadcast.
Select
SAP
audio
mode
for
the
eae
*
sub language. ;
Equipped with dbx®-TV Noise Reduction
for true MTS reproduction. dbx®-TV Noise
Reduction is required for good stereo
separation and audio fidelity. dbx® is a
registered trademark, and ts licensed by
dbx® Technology Licensing.
MONO broadcast
Normal monaural sound broadcast.
STOP
42:00AM ABC
0:00:00
STEREO SP
SAP
MONO 4
For assistance, call 1-800-211-PANA(7262).
20