:l
?
if!
I
i
il
m , L=
1
0
VCR Plus+ Channel Setup Is...
necessary to program the Unit with local
channel information for proper VCR Plus+
operation.
Process of Recording
IConnectionl lProgrammingl
At first, do Channel Setup Preparation below dght.
Display MAIN MENU.
1 % Press ACTION.
I_Check list before you begin.
[] It is necessaryto enter TV mode by
pressingDVD<--_TVbeforeselecting
"CH"on theMAIN MENU,
2
I Displa_ SET UP CH ACTION
_1__._[_ _ screen. 1)PressA,<{),"
to select "CH."
_--11--_--] 2) Press SET to
=_ display,
N, mEt_A : CABUE
N£tO SET
SIGNAL D I SPLAy :OFF
C/_U£ B0X SE'r UP
Select VCR Plus+ CH
SET UP.
1) Press AV to
@ select.
2) Press SET
to display.
4
VCR Plus* Ct'ISET UP
GUIDE OR Cid3LE 04
01 10
mm 22
Enter VCR Plus+ channel.
G)'_l 1) Press SETto
move cursor to
right column.
2) Press AV to
change the
CABLE CH
number.
3) Press SET to
set.
4) Press AV to
scroll up/down
the GUIDE CH
column.
To M_,keCorrections • Repeat step 4 _Jntil list is complete.
Press AV and SET to move to error, then AV to change,
or ADD/DLT to erase number.
End the setup.
Press ACTION three times.
• Make each entry within 5 minutes or the unit will leave this mode,
• Once local channels have been programmed, they will stay in
memory, even in the case of a power failure.
24
-'LECT
-2SET
4
Channel Setup Preparations
To complete step 4 left, make a local
channel list (see example below.)
You will need the following:
• A normal TV and/or Cable stations line
up and the channel numbers your receive
them on,
• A list of Guide (VCR Plus+) channel
numbers for stations you receive (See TV
Guide and selected newspapers.)
1 Make a 3-columns chart. In the left
column, write all station names you receive.
2 In the middle column, write each station's
Guido (VCR Plus+) number.
3 In the right column, write the channel
number your TV renaivee the station on.
< EXAMPLE ONLY •
Broadcast ' Asslgl_-_:l Channel
or Cable Guide no. your "IV
Station VCR Plus+) receives the
Name channel no. station on
HBO 33 15
Nickelodeon 38 20
CBS 04 04
FOX 11