Selectthedigitaloutputtobeoutputfrom the optical/ coaxial
digital audio output connector of the unit.
1
2
Do steps I and 2 on page 51,
1V MCOE : L_llCox
I
Display DIGITAL
AUDIO OUTPUT screen,
1) Press
to select.
2) Press
SET.
3
_IGITALAUOIO(_J'i'p¢_
Do_YDlIItIl:SltIWIm
dl :OFF
Select the desired
item.
(_],,(E) (1) Press &If'
I to select.
I 2) Press SET
I repeatedly
for output.
"LPCM (DVD)" selections
OFF: OnlylinearPCM of 48 kHz/16 bit is output,When
playingDVDs recordedin linearPCM of 48 kHzi20 bitor
96 kHz, nodigital audiois output.(Factorypreset)
PCM: When playingDVDs recordedin linear PCMof 48 kHz/
20 bit/24bitor 96 kHz, digitalaudio convertedto48
kHz/16 bitisoutput.
(Digitaloutputof PCM audio Isrestdctedto 48 kHz/16
bitor belowforcopyrightprotection.)
"Dolby Digital" selections
Bltstream: Dolby Digital (AC-3) bitstroam (2ch-5.1ch) is output,
(Factory preset)
PCM: PCM (2oh) of 48 kHz/16 bit is output.
"dts" selections
OFF: No output.(Factory preset)
Bltstream: dts bttstmam is output.
"Dynamic Range Compression" selections
OFF: Normal audio range is selected, (Factory preset)
ON: For dynamic sound even at low volume, this is useful for
late-night listening, [onlby Digital (AC-3) DVDs onlyI.
"V.S.S." selections
Vidual Surround Sound creates the effect of sound coming from
nonexistent rear speakers even when only connected to a
2-channel stereo system. (Dolby Digital (AC-3) DVDs only).
OFF: No Virtual Surround Sound affect..(Factory preset)
VSS 1: Natural effect.
VSS 2: Emphasized effect.
4 %
52
Redispley DVD menu
to continue setup.
Press ACTION and go
to step 2 to setup
another setting.
Or, to exit, press
ACTION three times.
ACTION
SELECT
"2 SET
3
Recommendable setting
Type of amplifier --
to be connected LPCM Dolby dts
_OVD)0_1
No amplifieris conoected OFF 3itstream OFF
AV amplifier(withdi_daf
I
audio
input¢omlecfor)
PCM.1 ! PCM*= OFF*2
withoutDofoyDigital/dts
decoder
!AVamplifierIncluding
DoibyDigitaldecoder PCM .1 ]itstraam OFF
_.Vamplifierincluding ,:
Dolby DipltaVdtsdecoder PGM.1 3itstmam Bitstrearr
• Make seffingsaccordingto amplifierconnectedto optical/
coaxial audio output8s shown lo above tabte.
• When a dts decoder is not connected, to enjoydis DVD,
please seksctaudio output other than(Its st the dts DVD
menu screen. Otherwise, there will be no soundfrom the
unitspeakers,
•1 Audio output from unit is convertedto 48 kHz/16
bit in additionto audio from digital audio output,
TO enjoy highqualitysound at 48 kH_ bit/24
bit or 96 kHz, connectthe amplifieror decoder
directlyto the audio cx_out connectors, nottothe digital
audio output connector. (Select"OFF"at _ "LFCM{DVD)".)
,2 When connectingan amplifier (withan optical/
coaxial digital inputconnector) whichdoes not
contain the DothyDigital (AC-3) or dts decoder,
be sora to soisct =PCM" o€"Off",
ff'Bltstraam" Is belaCied, sta_ng DVD play may cause •
such a h_ghk)velof noiso as to be harm_
to your ears and damage the speakers.
•3 When a dts decoder is connected,please select
•Bitstrssrn"in "dts'. If "OFF' is selected,there will be no
sound.
• The virtualsurroundeffect maynotworkpropedyforsome
DVD software.
•Tum off othersurroundeffectswhen usingIbisvidual
surroundeffect.
• Foroptimumeffect,the distancebebNeefltheunHand the
listenershoutdbe about3 or 4 tJmasthedistancebetween
the dg_ aed fortfront sbeakers.
ii[,]I_t.-I.-II.-II_nI[_I-.,II_.IiiI I;[ilo_-III _..'|_T!Y|I_'_41
To Next Page
Loading...
