Search System
For each recording, an invisible index mark is placed on the tape. A program index and
information are also included for timer recordings. These marks are used to access or
scan recordings.
E_,L
r_-_ 8ENt0H :RE_
Press SEARCH* to
display SEARCH in Stop
or Play mode, and then
press NUMBER keys to
select recording
number
• To calculate number,
see below.
Press FF or REW to
start search.
Locates end point of recording for continuity.
1 Press SEARCH twice to display SEARCH
in Stop or Play mode.
Press FF to start
PROGRAM END
SEARCH.
• TO cancel_ press
PLAY or STOP.
Play begins at search
end. To search forward
or back 1 index, press
FF or REW whi_e
screen left is displayed
(10 sac.).
• TO cancel, press
PLAY or STOP.
• To Calculate Index Number
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press
REW.
t 56 7
Example 2:
To go to rec. 6 from rec. 2, enter 4 and press
EF.
NOTE: _, indicates start points of each recording.
Examples of Program End Search.
• _ End Point
• _ " End Point
i
/
ifseoroh
End Point exceeds a few
seconds in
BLANK area.
Upon locating end point,
-_ search continues 7 sec. past end point,
-_ tape rewinds to 10 sec. before end point,
-_ tape plays to end point and stops.
• If Program End Search is started very
close to an index mark, that mark may be
skipped over.
• To cancel, press PLAY or STOP.
O
• If Index Search is started very close to an
index mark, that index mark may not be
counted in the search.
Set to playback a recording aver and aver.
1 Press ACTION to display menu,
AUtO V_TV :ON
8£:L E5% :_, • _: •
Press AV to selecl
REPEAT PLAY and
press • to set ON or
OFF.
ON :Play repeats at tape et_d
or if u_recorded portion
over 30 sac is detected
Press ACTION to return to normal screen,
To quickly return to a specified tape location.
1 Press DISPLAY during play
to display Counter.
Press RESET
COUNTER st desired
position to reset to
'O:OO:O0_.
3 Continue to record, playback, etc.
4 Press STOP.
5
@4 ¢2
4!-
Press CM/ZERO in Stop
mode to start ZERO
SEARCH.
• Unit will go into FF or
REW mode and stop at
the last point the
Counter was set to
0:O0:00.
VCR fast forwards (skips) over 1~3 minutes
of recorded tape.
1 Press CM/ZERO in Play mode,
• Press CMiZERO repeatedly to change
skip time as shown below.
PLAY
1st Press ---_q rain Skip
2rid Press---,-2 rain Skip
3rd Press---,-3 rain Skip
• No indication appears.
*Important: If a remote control button does not work when pressed,
press the VCR button on the remote and try the button again.
To Next Page
Loading...
