Fig. 6-1
4.1.9.2. (Electrical Method)
Apply +10.0 V DC Power Supply to the Loading Motor terminals.
Loading
DC + to Portion "a," DC - to Portion "b"
Unloading
DC - to Portion "a," DC + to Portion "b"
CAUTION:
Before applying DC Power Supply, be sure to cut the Motor Leads with a
cutter, etc.
Otherwise, the Loading Motor Drive IC (IC2501) may be damaged.
Fig. 6-2
When loading without a cassette, push Portion "a" on the Holder Unit of Cassette Up Ass’y so that the
Lever clear the First Tab and Second Tab.
Fig. 6-3
12
To Next Page
Loading...
