CAUTION:
Opener Lever may be damaged when Front Panel Ass’y is installed,
with Cassette Door-Lid of Front Panel Ass’y and Opener Lever of
Cassette Up Ass’y set incorrectly.
A. When installing the Front Panel Ass’y, swing the Cassette Door-Lid
all the way open until the Cassette Door tab clears the Opener Lever.
B. Make sure that all locking tabs are aligned properly.
Then, press the Front Panel straight in.
Fig. D1
3. Installation of Main C.B.A. & Mechanism Chassis onto the Frame
When installing 2 Screws (460), slide the Holder Unit of the Cassette
Up Ass’y (Refer to "
METHOD FOR LOADING/UNLOADING OF
MECHANISM" in Service Notes) to tighten screws. Then, slide it back
to the EJECT Position.
4. Installation of Mechanism Chassis and Cassette Up Ass’y onto Main
C.B.A.
A. Make sure the Mode Select SW. on the Main C.B.A. is in EJECT
position. If not, rotate the Mode Select SW. until the alignment
projection is in the EJECT Position.
Fig. D2
19
To Next Page
Loading...
