B. Install the Mechanism Chassis and Cassette Up Ass’y straight onto
the Main C.B.A. so that the Sensor LED clears the hole in the
Mechanism Chassis and that 2 Connectors (P4001, P6201) are
aligned and seated securely.
5. Flat Cable solder points on the Cylinder and AC Head
Solder the Flat Cables. Then, install the Shield Plate as shown.
Fig. D3
6. Installation of Cassette Up Ass’y
A. Confirm that the Locking Tab under the Cassette Up Ass’y is in Hole
on the Mechanism Chassis when installing the Cassette Up Ass’y.
Then, slide the Cassette Up Ass’y towards the back.
B. When installing 2 Screws (502), slide the Holder Unit (Refer to "
20
To Next Page
Loading...
