rotation" time (in hours) to 0. Refer to "USAGE SCREEN MODE" in
SERVICE NOTES.
5.2.5. Capstan Belt, Support Angle, Intermediate Gear B, and Main Cam Gear
Fig. J3-1
5.2.5.1. Reassembly Notes
1. Alignment of Main Cam Gear, Drive Rack Arm, and Main Rod
A. Confirm that the hole on Main Rod is a Through Hole with a hole on
chassis.
B. Confirm that the hole on Drive Rack Arm is a Through Hole with a
hole on chassis.
C. Install the Main Cam Gear so that the projection of Main Cam Gear
24
To Next Page
Loading...
