Search System
For each recording, an invisible index mark is placed on the tape. A program index and
information are also included for timer recordings. These marks are used to access or
scan recordings.
2
F S_A_H
_WTER W*O_X_UaER
I _KEYS
FO_W_ S_A_ Fr
R_E_S_ SF_CH _EW
Press SEARCH* to
display SEARCH in Stop
or Play mode, and then
press NUMBER keys to
select recording
number.
• To calculate number,
see below.
Press FF or REW on
the remote to start
search.
Locates end point of recording for continuity.
1Press SEARCH twice to display SEARCH
in Stop or Play mode.
Play begins at search
end. To search forward
or back 1 index, press F_
FF or REW on the
remote or VCR while -lit Progr=_1
screen left is displayed _._..,,__.S_H_
(10 sec.). •
• TO cancel, press
PLAY or STOP.
• TO Calculate Index Number
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press
REW.
Example 2:
To go to rec. 6 from rec. 2, enter 4 and press
FF.
NOTE: _ indicates start points of each recording.
Press FF on the remote
to start PROGRAM
END SEARCH.
• To cancel, press
PLAY or STOP.
Examples of Program End Search.
FiLQ__.2
• _ " End Point
FIQ.3 _,_ =_
|
_!_'='11 J'"_"< II _,,.2 II
End Poin_tt _,_j [If search
exceeds a few
seconds in
BLANK area.
Upon locating end point,
÷ search continues 7 sec. past end point,
-,- tape rewinds to 10 sec. before end paint,
÷ tape plays to end point and stops,
• If Program End Search is started very
close to an index mark, that mark may be
skipped over.
• To cancel, press PLAY or STOP.
• If Index Search is started very close to an
index mark, that index mark may not be
counted in the search.
-6-
To Next Page
Loading...
