5.3. CASSETTE UP ASSEMBLY SECTION
How to read chart shown above:
A: Order of Procedure steps.
When reassembling, perform steps(s) in reverse order.
These numbers are also used as the identification (location) No. of
parts in Figures.
B: Steps to be completed prior to the current step.
C: Part to be removed or installed.
D: Fig. No. showing Procedure or Part Location.
E: Identification of part to be removed, unhooked, unlocked, released,
unplugged or unsoldered.
(S-1) = Screw (S-1), (L-1) = Locking Tab (L-1), (W-1) = Washer (W-1), (P-
1) = Spring (P-1), (C-1) = Cut Washer (C-1)
F: Alignment/Adjustment which is required when installing or replacing
each Parts.
5.3.1. Top Plate, Wiper Arm Unit, and Holder Unit
Fig. K1-1
34
To Next Page
Loading...
