Panasonic Palmcorder Palmsight PV-L559 - Page 11

Supplying Power
"Battery Refresh |
This feature completely discharges Battery before recharging begins.
Use after about every 5 charges for optimum Battery performance.
CHARGE Lamp
l 1 Plug in AC Adaptor.
« POWER Lamp stays on as long as
Adaptor is plugged in.
)
Place Battery into Adaptor.
1 3 Press BATTERY REFRESH.
The CHARGE Lamp flashes during
discharge then stays lit until charging
is complete.
lf BATTERY REFRESH is pressed
by mistake, remove Battery from
3 BATTERY Adaptor and reinsert it for normal
REFRESH charging.
4 Remove Battery.
* Charging takes about 7 and 1/2 hours
when Battery Refresh is used.
* Battery will not operate in extremely high
temperatures:
Battery Care
Caution: To avoid Battery damage:
* Charge only with specified charger. * Do not drop or jar Battery.
* Battery can be charged within a temperature * Use Battery with specified units only.
range of 50° F (10° C) and 95° F (35° C). » If Battery is used in extremely high
* Battery is normally warm after charging or just temperatures, a safety device will
after use. automatically.prevent operation.
+ Do not use an insufficiently charged or worn-
out Battery. To prolong Battery life:
+ While not in use, remove Battery from the '
Camcorder and AC Adaptor and store ina
cool, dark, dry place.
* Keep Battery terminals clean.
Safety precautions:
* Do not get Battery near, or dispose of in fire.
* Do not directly connect (short circuit) the
positive (+) and negative (—) terminals.
* Never attempt to disassemble or reassemble
Battery.
U.S.A. CONSUMERS:
ATTENTION:
The product you have purchased is powered by a nickel cadmium battery which is
recyclable. At the end of its useful life, under various state and local laws, it is illegal to
dispose of this battery into your municipal waste stream. Piease call 1-800-8-BATTERY
NiCd for information on how to recycle this battery.
La
11