Panasonic Palmcorder Palmsight PV-L559 - AC Adaptor; DC in; DC Power Cable

Supplying Power
| AC Adaptor |
DC Power Cable
Connect AC Adaptor VCR DC OUT
á to Camcorder DC IN with supplied
DC |
POWER Lamp i ieee 9 DC Power Cable.
Ne
* AC Adaptor cannot power Camcorder while
VCR DC OUT Connector charging Battery.
¢ When not in use, unplug AC Adaptor from AC
outlet. (Adaptor uses 1.2 W of electricity while
plugged in.)
Plug in AC Adaptor.
POWER Lamp lights.
CAUTION:
This unit will operate on 110/120/220/240V AC. An AC plug adaptor may be
required for voltages other than 120V AC. Please contact either a local or foreign
electrical parts distributor for assistance in selecting an alternate AC plug.
We recommend using the accessory power plug adaptor (VJSS0070) in an area
which has specia! AC outlets.
Car Battery Cord (Optional)
Connect PV-C16 Car Battery Cord
(optional) to Camcorder DC IN.
2 A Start engine first.
B Plug Car Battery Cord into
Cigarette lighter socket.
* If Car Battery cord fuse needs
replacing, use exact current rating
(in amps).
DC IN
Connector f
Cigarette Lighter Notes:
Socket (12V) * This cord only works in vehicles equipped
ee with DC 12V (negative ground) battery.
Check with your car/truck dealer. Use
only specified car battery cord.
* To avoid blowing the car battery cord
fuse, do step 2 in the proper order.
* Running vehicles must be well ventilated.
+ When not in use, disconnect cigarette
Car Battery Cord Cigarette
(optional) Lighter Plug lighter plug.
12 ‘ For assistance, call 1-800-211-PANA(7262)