Panasonic Palmcorder PV-D300 - Copying Your Tapes (Dubbing)

Copying your Tapes (dubbing)
Source (Playing)
Camcorder
II IIIII I
Before you begin...
• Make Camcorder-VCR connections
(see left).
• Turn both units on.
• Set VCR input signal to LINE.
Please see VCR owner's manual.
• Set Camcorder POWER to VCR.
1
2
Insert a regr_:_corded tape
into Camcorder and a blank tape with
record tab into VCR.
Press PLAY on Camcorder, then
press STILL at starting point.
"u'° 'e°l llo t
Connecting
Cable (not supplied) " --_ '
Recording:
/ vc___
o0o
LI
To Audio-_--To Video
_r______Yin
Audio/Video Cable
(supplied)
3
4
Press RE C, then STILL/PAUSE on
VCR.
5
Press STILL on Camcorder and
STILL/PAUSE on VCR again to start
copying.
Press STOP on both units to stop
copying.
Note:
• Camcorder will only playback tapes
recorded in SP or SLP mode.
• Dubbing may reduce picture quality.
• ;__._i (,lira _,rUb,i,- iv--.
• Turn TV on and tune to VCR
channel (CH3 or CH4).
• Set TV/VCR Selector on VCR to VCR.
i CAUTION:
nauthorized exchanging and/or |
opying of copyrighted recordings may
J
e copyright infringement.