21
Basic Operation
Before you begin...
• Make Camcorder-VCR connections (see left).
• Turn both units on.
• Set VCR input signal to LINE.
Please see VCR owner’s manual.
• Set Camcorder POWER to VCR.
1
Insert a pre-recorded tape
into Camcorder and a blank tape with
record tab into VCR.
2
Press PLAY on Camcorder, then press
STILL at starting point.
3
Press REC, then STILL/PAUSE on
VCR.
4
Press STILL on Camcorder and STILL/
PAUSE on VCR to start copying.
5
Press STOP on both units to stop
copying.
Note:
• Camcorder will only playback tapes
recorded in SP or SLP mode.
• Dubbing may reduce picture quality.
CAUTION:
Unauthorized exchanging and/or copying
of copyrighted recordings may be
copyright infringement.
Copying your Tapes (dubbing)
Audio/
Video Out
Connections
• Turn TV on and tune to VCR channel
(CH3 or CH4).
• Set TV/VCR Selector on VCR to VCR.
Monitor with your TV
Source
(Playing)
Camcorder
PLAY
STILL
STOP
04.L152 Basic p19-21 02.2.18, 1:38 PM21
To Next Page
Loading...
