102
LSQT0969
Installation (Windows)
With a computer (VDR-D200 only)
5 Read carefully through the End User License
Agreement (l 100), then click [Yes].
≥ You cannot install the application if you click [No].
6 Click [Next].
Continue to follow the on-screen messages to install it.
7 When installation is complete, some notes will appear:
Check the contents, then click [k] at the top right of
window.
8 Click [Finish].
Windows 2000 only:
The detection of device will start, after which it will take several minutes
for the computer to detect the device. When detecting the device is
complete, a message that prompts you to reboot will appear:
Click [Yes].
∫ If any trouble has occurred while installing DVD-RAM Driver:
When the [Block] is selected in the [Driver Signing Options] in the [System Properties], the
installation procedure will not complete. Select [Warn] and try again.
To check and change the setting, select [start] # ([Settings] #) [Control Panel] # ([Performance
and Maintenance] #) [System] and select [Driver Signing] of the [Hardware] tab.
∫ To download the DVD-RAM Driver from the website (VDR-D100 only)
If your computer is able to connect to the Internet, you can download the DVD-RAM Driver from the
website below.
U.S.A.: http://www.panasonic.com/consumerdownloads
Canada: http://www.panasonic.ca/english/customercare/downloads.asp
1) Download the DVD-RAM Driver software and execute it.
2) Follow the on-screen instructions for installation and reboot the computer after installation is
complete.
The computer must be rebooted for the driver to work.
D200(P_PC)eng.book 102 ページ ２００６年１月１８日 水曜日 午後５時４６分
To Next Page
Loading...
