Chapter 6 Using Linker
Command Options 101
Functional description
The linker normally suppresses the creation of an executable file if it detects errors during linking. This
option forces file creation even if there are errors.
NOTE: An executable created with known linker errors will not execute properly. The r
option is only a temporary measure. Do not run the executable that results.
Rules of use
This option is specified with the hyphen (-) option specification character, followed by the lower-case
letter 'r'.
ld103 -r prog1.rf
Default specification
An executable format file will not be generated.
It is also possible to force creation of executable file by default with an entry in the linker’s start-up
file. See Chapter 1 “Getting Started” Section 1.5 “Setup”.
r Output an executable format file even if errors are detected
To Next Page
Loading...
