Chapter 13 Error Messages
254 Assembler Errors
13.2.2 Error Messages
2301 Syntax error.
The current line contains a syntax error.
Consult this Manual and the MN1030/MN103S Series Instruction Manual.
2302 Illegal character.
A string contains an illegal character.
Use only legal characters
2303 Illegal string.
A string contains an error.
Correct the string.
2304 Instruction not found
The specified instruction does not exist.
Consult this Manual and the MN1030/MN103S Series Instruction Manual.
2305 Code size overflow.
A section contains too much code.
Divide the section into smaller parts.
2306 Multiple define symbol.
A symbol is defined more than once.
Use different symbol names.
2307 Illegal symbol name.
There is an error in a symbol name.
Change the symbol name.
2308 Label (symbol) is reserved word.
A reserved word is used as a label.
Change the label name.
2309 Label not permitted.
A label specification is not permitted here.
Eliminate the label specification.
2310 Label nothing.
The label specification is missing.
Specify a label.
2311 Illegal operand size.
An operand is of the wrong size.
Check the size specification.
2312 Out of section error.
A specification is not inside a section.
Move the specification inside a section.
2313 Section name count over (max 255)
There are more than 255 section names.
Reduce the number of section names to within 255.
To Next Page
Loading...
