14
Radio
(FM stereo) indicator
lights while receiving an FM
stereo signal.
Operation Flow
1
Press [SRC] to select the radio source.
2
Press [BAND] to select a band.
Weather Band
(a page 15)
3
Select a station.
Frequency Adjustment
[TUNE{]: Lower / [TUNE}]: Higher
Note: For station search, hold down either of the but-
tons for more than 0.5 seconds and release it.
Preset Station Selection
Press the corresponding preset button
from [1] through [6] to tune in a preset
station.
Display Change
Press [DISP] to change the display.
Radio mode display (Frequency)
Clock display
Station Preset
The 6 stations with good reception will be automati-
cally saved in the memory under preset buttons [1]
through [6].
Preset stations can be simply called up by pressing
[1] through [6].
Auto Preset Memory (APM)
With this operation, stations with good receiving
conditions can be automatically stored in the preset
memory.
1
Select a band.
2
Hold down [BAND] (APM) for more than
2 seconds.
The preset stations under best receiving condi-
tions are received for 5 seconds each after preset-
ting the stations (SCAN). To stop scanning, press
one of the buttons from [1] through [6].
Note: New stations overwrite existing saved stations.
Caution
To ensure safety, never at-
tempt to preset stations while
you are driving.
[SRC]
selects a source.
[DISP] (Display)
switches the information
on the display.
[BAND]
selects a band in the
radio source.
(APM) (Auto Preset
Memory)
executes APM in the
radio source (by hold-
ing it down for more
than 2 seconds).
[TUNE}] / [TUNE{]
increases/decreases the fre-
quency. (For seek tuning, hold it
down for more than 0.5 seconds
and release it.)
Preset buttons [1] through [6]
select a preset station in the radio source,
preset the current station (by holding it
down for more than 2 seconds).
cd
To Next Page
Loading...
