16-E
NGLISH
(continued from previous page)
Connector panel
# SERIAL connector (pages 21, 22, 23 and 70)
This connector is used to connect a personal computer to the projector in
order to control the projector externally. (RS-232C compatible)
$ PC 1 IN connector (pages 21 and 22)
This connector is used to input RGB signals and YPBPR signals.
1 DIRECT INPUT SELECT buttons (pages 27 and 30)
You can select the input signal directly by pushing these buttons.
2 SHUTTER button (page 32)
This button is used to momentarily turn off the picture and sound. You can
also select this function from the on-screen menu (refer to page 53).
3 DEFAULT button (page 39)
This button is used to reset the projector adjustment values to the factory
default settings.
4 VOLUME +/- buttons (page 32)
These buttons are used to adjust the volume of the sound that is output
from the projector’s built-in speaker and VARIABLE AUDIO OUT
connector. Refer to page 52 for details on how to adjust the volume
without using the remote control unit.
5 DIGITAL ZOOM +/- buttons (page 33)
These buttons are used to enlarge the projected image.
To Next Page
Loading...
