6 Disassembly Instructions
Warning:
·
Be sure to unplug the power cord from the power outlet before disassembling this projector.
Caution:
·
While turning over a printed circuit board, be sure to put a insulating material under it to prevent a short circuit.
·
Printed circuit boards and wires must not be pulled forcibly, but be handled carefully.
·
Connectors also must be handled carefully.
·
After repairing this projector, be sure to put back the wires and connectors to the original condition.
6.1. Printed Circuit Board and Main Parts Location
Electrical Parts
Optical Parts
10
PT-P1SDU / PT-P1SDE / PT-P1SDEA
To Next Page
Loading...
