Panasonic PV-D4742 - Tape Operation: Search System; Index Search; Program End Search

SERVICE NOTES.
5.2.5. Capstan Belt, Support Angle, Intermediate Gear B, and Main Cam Gear
Fig. J3-1
5.2.5.1. Reassembly Notes
1. Alignment of Main Cam Gear, Drive Rack Arm, and Main Rod
A. Confirm that the hole on Main Rod is a Through Hole with a
hole on chassis.
B. Confirm that the hole on Drive Rack Arm is a Through Hole with
a hole on chassis.
C. Install the Main Cam Gear so that the projection of Main Cam
Gear is in the upward position as shown.
Fig. J3-2
30