height. If the envelope drop appears on the right-half of the
waveform, adjust P3 post height.
CAUTION:
Overtightening P2 and P3 posts may cause the threads to strip.
Note:
It will be possible to confirm Step 6 according to following steps.
1. Release the Tracking center mode.
2. Press the Tracking Control Up or Down button on remote control.
Make sure that the envelope waveform remains flat. If not,
readjust P2 and/or P3 post heights.
Fig. M3-1
Fig. M3-2
7. After adjustment, confirm that the tape travels without curling at
P2 and P3 posts.
Fig. M3-3
8. To release from Tracking center mode, press PLAY or STOP
button.
6.2.2.2.2. AUDIO CONTROL HEAD TILT ADJUSTMENT
Purpose:
46
To Next Page
Loading...
