W FLMPRF:
Wirewound Flameproof
C.B.A.:
Circuit Board Assembly
P.C.B.:
Printed Circuit Board
E.S.D.:
Electrostatically Sensitive Devices
3. When replacing 0 resistor, a wire can be substituted for it.
4. Since the UHF/VHF TUNER/TV DEMODULATOR UNIT (Ref. No.
743) has already been pre-adjusted at the factory, do not try to
adjust the UHF/VHF TUNER/TV DEMODULATOR UNIT. The UHF/
VHF TUNER/TV DEMODULATOR UNIT replacement part is
available as a complete assembly unit only.
5. EEP ROM IC (IC6005), MAIN C.B.A. replacement note:
After replacing EEP ROM IC (IC6005) or MAIN C.B.A., be sure to
perform the “PG SHIFTER ADJUSTMENT” in ELECTRICAL
ADJUSTMENT procedures.
6. EEP ROM IC (IC8001), DVD Decoder C.B.A. replacement note:
After replacing EEP ROM IC (IC6005) or DVD Decoder C.B.A.,
confirm the Firmware version of DVD using Self-Diagnostic
function.
If the version is different than that indicated on the Firmware Disc,
update it using the Firmware Disc. Refer to “HOW TO UPDATE
THE FIRMWARE OF DVD.”
11.2. MECHANICAL REPLACEMENT PARTS LIST
MECHANICAL REPLACEMENT PARTS
63
To Next Page
Loading...
