36
Search System is ...
Each time a recording is made, an invisible index
mark is placed on the tape. When timer recordings
are made, program index and information are
also included. These index marks can be used to
access or scan recordings.
1
Press SEARCH*
in Playback or
Stop mode to
display INDEX
SEARCH screen,
and then press
NUMBER keys to
select the
recording number.
• To calculate
number, see below.
Index Search
Go directly to the desired recording.
• If Index Search is started very close to an index mark,
that index mark may not be counted in the search.
2
Playback begins
at search end. To
search forward
or back 1 index,
press FF or REW
while screen left
is displayed (10
seconds).
NOTE: indicates start points of each recording.
61572 34
■ To calculate the Index Number
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press
REW.
17534 62
Example 2:
To go to rec. 6 from rec. 2, enter 4 and press FF.
ENTER
I
NDEX
NUMBER
:
1
US
I
NG 1
-
9
KEYS
FOR
W
ARD
SEARCH
:
FF
REVERSE SEARCH
:
REW
EX
I
T
:
SEARCH
I
NDEX SEARCH
FOR
W
ARD
SEARCH
:
FF
REVERSE SEARCH
:
REW
I
NDEX SEARCH
To cancel, press PLAY.
Repeat Play
Set to see a recording over and over.
PLAY
REPEAT ON
To turn “ON,”
press PLAY/REPEAT on the unit repeatedly in
Playback mode to select “REPEAT ON.”
To turn “OFF,”
repeat above to select “REPEAT OFF.”
• Playback repeats when tape end is reached or
an unrecorded portion longer than 30 seconds is
detected.
• For repeat play in DVD mode, see pages 60-61.
Tape Operation
Press FF or REW to start search.
Note
Note
Press CM/ZERO repeatedly to select skip
time in Playback mode.
Commercial Skip
By pressing the CM/ZERO button in Playback mode
you can skip over 1 to 3 minutes of recorded tape in
just a few seconds.
• No indication appears.
OFF
1st Press 1 min skip
2nd Press 2 min skip
3rd Press 3 min skip
To Next Page
Loading...
