used to install the F.P.C. to the Non ZIF Connector.
Fig. 4
5.1.6. METHOD FOR LOADING/UNLOADING OF MECHANISM
CAUTION:
If loading does not start after DC Power Supply is applied, DO NOT
continue to applying DC Power Supply.
Apply+3 VDC Power Supply to the Loading Motor terminals.
Loading:
DC - to Portion "a," DC+ to Portion "b"
Unloading:
DC+ to Portion "a," DC - to Portion "b"
Fig. 5
5.1.7. SIGNAL DESCRIPTION ON INTERFACE BOARD FOR ELECTRICAL
11
To Next Page
Loading...
