5.1.8. HOW TO REMOVE A JAMMED TAPE
5.1.8.1. Electrical Method
CAUTION:
If loading does not start after DC Power Supply is applied, DO NOT
continue to applying DC Power Supply. In this case, perform in
Manual Method.
Remove a jammed tape as follows:
1. Remove the Cabinet Parts. Refer to "CABINET SECTION" in
DISASSEMBLY/ASSEMBLY PROCEDURES.
2. Apply+3 V DC Power Supply to the Loading Motor terminals.
3. When the Loading Posts reach the fully unloaded position,
remove the Power Supply immediately.
Note:
DO NOT let eject the Garage Unit. If the Garage Unit is in the up
position, the DV Cassette Tape may be damaged.
Fig. 6-1
15
To Next Page
Loading...
