Note:
Do not glue the replacement leadless component to the circuit
board.
5.1.15. IC6001 REPLACEMENT NOTE
Three types of IC6001 (M32121FCAWG, M32121MCA100, or M32121MCA101) are used on a
running change basis. When replacing IC6001, as in cases like the following, it is necessary to
replace the resistor at the same time. Otherwise, IC6001 may have ashort life.
Be sure to confirm the part numbers of both the original IC6001 and the new one supplied as
shown:
Case1:
When replacing IC6001 (M32121FCAWG) with IC6001 (M32121MCA101), be sure to remove
resistor (Ref No. R6027). Then, install it to R6076.
Case2:
When replacing IC6001 (M32121MCA100) with IC6001 (M32121FCAWG), be sure to remove
resistor (Ref No. R6076). Then, install it to R6027.
Fig. 11-1
Fig. 11-2
5.1.16. IC401 REPLACEMENT NOTE
(For model with Memory Slot)
27
To Next Page
Loading...
