Panasonic PV-DV950 - Battery Operations; Charging the Battery; Inserting and Removing the Battery

Supplying
Power
with the
Battery
The Battery
was
only
minimally
charged
before
shipping.
Therefore,
fully
charge it
before
you use
it
for the
first
time.
1
Place the
Battery
on the
AC Adaptor
as
shown
above and
slide
it horizontally
until it stops.
2
Connect
the
AC Power
Cord to an
AC
Outlet.
3
When all
four
Charge
Lamps
on the
AC
Adaptor
are lit,
charging
is
finished.
4
Remove
the Battery
by sliding
it in the
opposite
direction
of
Step 1
above.
•Also
disconnect the
AC Power
Cord.
5
Slide the [BATT
DOOR
OPEN]
Lever.
6
Open
the Battery
Compartment
Cover.
7
Insert
the Battery
with
O
pointing
inside.
8
Close
the
Battery
Compartment
Cover
so
that it
locks
with
a
click.
Removing
the Battery
Open
the
Battery
Compartment
Cover
and push the
Battery
Eject Lever
©.
+
Hold
your hand over the
Battery
Compartment
to
prevent the Battery from
dropping.
Before removing the Battery,
set the [POWER
ON/OFF] Switch to [OFF].
Caution
Be sure
to insert the Battery with the
[A] mark pointing
into
the Movie Camera. If
you insert it with
the mark
pointing
outside,
it could
damage
the Movie
Camera.
-12-