Panasonic PV-GS80 - Playback Operations; Playback Modes and Controls

Playback mode
Playback mode
Playing back tape
IIII_WIIIIIIIIIIIIIIWIIIIIIIIIIIIWIIIIIIIIII_IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII_WIIIIIIIIIII_IIIIIIIIIIIW
• Set to Tape Playback Mode.
[An operation icon automatically appears on
the LCD monitor.)
1 Operate with joystick.
Playback/Pause
I_/11:
_1_1: Rewind/Review playback (Reverts to
playback with the I_/! ! icon.)
I_1_: Fast forward/Cue playback (Reverts to
playback with the I_-/I ! icon.)
m: Stop
• The power will not turn off when the LCD
monitor and the viewfinder are closed and
retracted during Tape playback mode.
• During cue/review playback, fast-moving
images may show noise as a mosaic.
• Before and after cue/review playback, the
screen may become blue for a moment or
images may be disturbed.
• To adjust volume
Adjust the speaker volume for playback.
1 Move the [--_/VOL+] lever to adjust the
volume.
W T
Towards [+]: increases the volume
Towards [ ]: decreases the volume
(The nearer the bar is to [+], the higher the
volume.)
• When the adjustment is completed, the volume
indication will disappear.
• If you do not hear the sound, check the settings
of [SETUP] >> [12bit AUDIO].
• Repeat playback
When the tape end is reached, the tape will be
rewound and played back again.
1 Set [ADVANCED] >> [REPEAT PLAY] >>
[ON].
• The [(_.)_.] indication appears. (In order to
cancel the repeat playback mode, set
[REPEAT PLAY] >> [OFF] or turn off the
power.)
Settings on the audio
• If you cannot listen to the desired audio when
playing back a tape, check the settings in
[SETUP] >> [12bit AUDIO].
• When you record the audio in [12bit] and set
[SETUP] >> [12bit AUDIO] >> [MIX], the audio
will be played back in stereo sound regardless
of the settings in [AUDIO OUT].
4O
LSQT1121