2-13
Stopper
Capstan Rotor
Unit Shaft
Top of
chassis
Press
support
Capstan
Holder Unit
S Brake Arm Unit, Main Lever Guide, Loading
Post Base -S, and Loading Post Base -T Unit
Disassembly Procedure
1. Remove the S Brake Arm Unit while releasing 2 Locking
Tabs (H).
2. Remove the Main Lever Guide while releasing Locking Tab
( I ).
3. Slide the Loading Post Base -S and T Units to the end of the
guide slots to remove.
Fig. J10
Reassembly Notes
1. Adjustment of Loading Post Base -S Unit and Loading
Post Base -T Unit
1) After installing, perform the "P2 and P3 Post Height
Adjustment Procedures" and "Tape Interchangeability
Adjustment/Confirmation Procedures."
Capstan Rotor Unit, Capstan Holder Unit,
and SS Brake Arm Unit
Disassembly Procedure
1. Remove the Capstan Belt.
2. Cut the Stopper with a cutter to remove.
3. Pull up on the Capstan Rotor Unit.
4. Remove 3 Screws (B). Then remove the Capstan Holder
Unit.
5. Unhook Spring (B).
6. Turn the SS Brake Arm Unit so that the Tab (A) lines up with
the niche. Then, remove the SS Brake Arm Unit.
Fig. J11-1
Reassembly Notes
1. Installation of Capstan Rotor Unit
1) Insert the Capstan Rotor Unit Shaft to the hole of the
Capstan Holder Unit.
2) Place a support under the Capstan Rotor Unit shaft.
Install the Stopper. Be careful not to scratch the shaft or
Capstan Holder Unit.
3) Remove the support. Press the top end of the shaft
down so that the Stopper is properly positioned.
You should be able to move the shaft up and down
slightly when properly positioned.
Fig. J11-2
2. Capstan Rotor Kit
Capstan Rotor Unit, Capstan Holder Unit, and Stopper are
supplied as a Capstan Rotor Kit only. (Kit No. VXPS0382K)
They are not reusable. If removed, install a new one.
Because even invisible scratches on the Shaft of Capstan
Rotor Unit and the Capstan Holder Unit, made when cutting
the Stopper, could cause unstable tape path running.
Locking
Tab (I)
22 Loading Post
Base -T Unit
21 Loading Post
Base -S Unit
20 Main Lever Guide
Locking Tabs (H)
Locking Tabs (H)
View "A"
"A"
19 S Brake
Arm Unit
23 Capstan
Rotor Unit
Capstan Rotor
Unit Shaft
Stopper
Screws (B)
24 Capstan
Holder Unit
Capstan Belt
25 SS Brake Arm
Unit
Spring (B)
turn
Tab (A)
Stopper
Capstan
Rotor
Unit
Shaft
cut
Top View
To Next Page
Loading...
