1. Press and hold STOP, PLAY, and VOL DOWN buttons on the unit
together over 5 seconds with no cassette inserted.
The adjustment overlay will appear to Enter EVR Adjustment mode.
Fig. 5-1
2. Set the Default value of all Control functions using a remote
control as shown in "Memory IC Reference Table."
Note:
For Selecting Control functions and setting Default value, refer to "
How to enter EVR adjustment mode" and "HOW TO ENTER EVR
PG SHIFTER ADJUSTMENT MODE" in ELECTRICAL
ADJUSTMENT procedures.
Fig. 5-2
3. Press and hold STOP, PLAY, and VOL DOWN buttons on the unit
together over 5 seconds again or press the POWER button OFF to
release EVR Adjustment Mode.
The Default value will be written to Memory IC (IC6004).
4. Perform all EVR Adjustments. (Refer to "EVR (Electronic Variable
Register) ADJUSTMENT WITH THE REMOTE CONTROL" in
ELECTRICAL ADJUSTMENT procedures.)
14
To Next Page
Loading...
