Before applying DC Power Supply, be sure to cut the Motor Leads
with a cutter, etc.
Otherwise, the Loading Motor Drive IC (IC2501) may be damaged.
When reconnecting the Motor Leads, solder at below / 320 °C for
less than 3 seconds.
Fig. 6-2
When loading without a cassette, push Portion "a" on the Holder Unit of Cassette Up Ass’y so
that the Lever clear the First Tab and Second Tab.
Fig. 6-3
5.1.10. HOW TO REMOVE A JAMMED TAPE
CAUTION:
Wiper Arm Unit may be damaged or its spring may be out of place
when the jammed tape is removed by force.
Remove a jammed tape as follows:
5.1.10.1. Manual Method
16
To Next Page
Loading...
