EasyManua.ls Logo

Panasonic RP-BTS10 - Charging the Unit; Charging Terminal Safety

Panasonic RP-BTS10
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
The product illustrations may differ from the actual product.
Part names
1
Earphone
2
Remote controller
3
LED indicator light*
The number of blinks or color
notifies the status of the unit.
(* hereafter referred to as “LED”)
4
Charging terminal (DC IN)
Open the USB lid and connect the
USB charging cord (supplied) to
this terminal when charging. (See
“Charging”)
5
USB lid
6
Microphone
7
Cord adjuster
8
Battery case
(Please remove the battery when
disposing of this product.
→P.11
)
9
Clip
10
Volume + / Next
11
Power / Pairing / Play / Pause /
Call
12
Volume – / Previous
Remote controller
The rechargeable battery (installed in the unit) is not charged initially. Charge
the battery before using the unit.
1
Connect this unit to a computer
using the USB charging cord
The LED will light in red.
The LED lights in red when charging
is in progress. When charging is
completed, the LED will go out.
Charging will take approximately
1.5 hours from empty state to fully
charged. (Quick charging time for
60 minutes operation: Approx. 20 minutes)
Computer
USB charging cord (supplied)
1.5 hours
Off
2
Close the charging terminal cover securely
Do not touch the charging terminal with wet hand
If sweat or liquid is attached to the charging terminal, malfunction may occur.
Note
The Bluetooth
®
feature cannot be used when this unit is connected to a computer
using the USB charging cord.
Charge in a room temperature of between 10 °C and 35 °C.
The power cannot be turned on while charging.
Do not use any other USB charging cords except the supplied one.
If PC used for charging enters “sleep mode”, charging may not take place.
Charging
Preparation
Left Right
Note
Tightening the cord too short using the cord adjuster
7
will cause the clip
9
to
open and not fit securely.
It is recommended that the cord not be overly tight so as to allow for a proper fit
and normal movement.
Do not use any other USB charging cords except the supplied one.
When using the unit, do not cover the remote controller with the palm of your
hand. The Bluetooth
®
connection may be blocked.
11
12
10
1
4
2
3
5
6
8
7
9

Related product manuals