Panasonic RP-NJ300B - Turning the Power On;Off; Connecting a Bluetooth Device

5
Connecting a Bluetooth
®
device
Preparation
• Place the Bluetooth
®
device within approx. 1 m from the unit.
• Check the device operation using its operation instructions as required.
Pairing (Registration) this unit with the Bluetooth
®
device for
connection
1
In the power-off state, press and hold the power button of this
unit until the LED blinks
When pairing a device for the first time : approx. 3 seconds
When pairing a second or subsequent devices : approx. 5 seconds
• The unit starts to search for the Bluetooth
®
device for connection, and the
LED will blink in blue and red alternately.
2
Turn on the power of the Bluetooth
®
unit, and enable the
Bluetooth
®
function
3
Select “RP-NJ300B” from the
Bluetooth
®
device’s menu
• The MAC address “□□□□□□” (“□” stands for a
character that is unique to each set.) may be
displayed before “RP-NJ300B” is displayed.
• If prompted for a passkey, input the passkey
“0000 (four zeros)” of this unit.
Bluetooth
Bluetooth
RP-NJ300B
Device
ON
Select
(Ex.)
4
Check the connection with the
Bluetooth
®
device on the unit
• The LED will blink in blue and red alternately
until the connection with the device is
completed. When an electronic sound beeps
and the LED (blue) blinks twice every approx.
2 seconds, pairing (registration) is completed.
(Connection established)
■
Note
• If connection to a device is not established within approximately 5 minutes, the
unit will be turned off. Perform pairing again.
• You can pair up to 8 Bluetooth
®
devices with this unit. If a 9th device is paired,
the device with the oldest connection will be replaced. To use it, perform pairing
again.
1
In the power-off state, press and hold the
power of this unit for approx. 3 seconds until
the LED (blue) blinks
• A beep will sound, and the LED (blue) on the remote
controller will blink slowly.
Power
LED
To turn the power off
• Press and hold
for approximately 3 seconds.
A beep will sound and the power will be turned off.
■
Note
• When the unit is not operated for approximately 5 minutes, the power will
automatically turn off. (See “Auto power off” (→ P. 7))
Turning the power on/off