Panasonic RS-4360DFT - Page 6

AUTOMATIC RADIO-OFF SYSTEM
The automatic stop system in this set makes it possible for the
radio to play and switch off at a pre-selected time.
Procedure:
1) Adjust the set for radio operation.
2) Insert the cassette, and lock the Playback Lever@ (or lock
both the Playback@ and Record@® Levers simultaneously
if you want to record radio programs).
3) Turn the Power/Function Switch® to the SLEEP position.
You can listen to the radio (and record at the same time) only
while the tape is moving.
When the tape reaches the end, the automatic stop system
will operate to release the Playback Lever@® (and the Record
Lever@), and the power will be shut off.
The time taken for automatic power-off depends on the length
of the tape remaining on the supply reel of the cassette. Refer
to the following table for the one-side playback (or recording)
times.
[Type of cassette [One-way time |
| co | 80 minutes
[cso a minutes |
This sleep timer is handy for:
@ Listening to a radio program while falling asleep.
@ Listening to a radio program and simultaneously recording
the program on the loaded tape while falling asleep.
PLAYING BACK THE CASSETTE
1) Set the Power/Function Switch@® to RADIO OFF/TAPE.
2) Depending on the cassette used, push the Equalization®
and Bias@ Switches as follows:
Type of cassette EQ switch@ BIAS switch@
CrO2 ON (Lock) ON (Lock)
ON (Lock) OFF (Release)
3) Open the cassette compartment with the Eject Lever@, and
insert the cassette as shown in Fig. 9.
Fig. 9
4) Depress the Playback Lever@, and playback will begin.
5) To stop the playback, depress the Stop Lever@®.
At the end of the tape, the Playback Lever@ will be auto-
matically released and the power will be shut off.
Note:
When amplifying playback sound with other equipment con-
nected to the Line Output Jack @ or DIN Connector Jack@,
adjust the Volume Control@ to the minimum level.
Fast-Forward and Rewind
Except when recording, the tape can be rapidly advanced or
rewound by depressing the Fast-Forward Lever@ or Rewind
Lever@. When the tape reaches the desired position or the
end, depress the Stop Lever@® to release the Fast-Forward ot
Rewind Lever.
MEMORY REWIND AND AUTO-PLAY
The Memory Rewind/Auto-Play feature allows the tape to be
rewound to automatically stop, or stop and then play back, the
tape at a preset location on the tape.
Procedure:
1) During recording or playback (or while the tape is station:
ary), press the Counter Reset Button® at the point on the
tape where the desired program begins. The Tape
Counter@ will read ‘‘000’’.
2) Press the Memory Rewind Switch@.
3) When the recording or playback is finished, depress the
Rewind@ and Playback@ Levers at the same time; the
tape will be rewound, the Tape Counter@ will count dowr
to ‘000’, then stop (overshooting slightly), and the tape
will then begin to play again.
If only the Rewind Lever@ is depressed, the tape will re-
wind until the counter@ indicates ‘‘000’’ and then stor
(overshooting slightly).
4) To cancel the Memory Rewind operation, press the
MEMORY/MPS-Off Switch@.
MEMORY PROGRAM SELECTION AND
AUTO-PLAY
When setting the Memory Program Selection system for list-
ening to a music tape, for instance, the set will select auto-
matically the desired program on the tape and play will begin
automatically from the start of that program.
Procedure:
1) Press the Memory Program Selection Switch@.
2) Set the Memory Program Selector@ to the desired posi-
tion. If it is set to position ‘'5’’, the selection system will
count the intervals between the programs starting from the
one which is ready to be played back, it will stop the tape at
the fifth interval, and the tape will be played back automati-
cally from that position.
3) Depress the Fast-Forward@ or Rewind@ Lever with the
Playback Lever@® locked.
4) To cancel the Memory Program Selection operation, simply
press the MEMORY/MPS-Off Switch@.
Note:
* If the Memory Program Selector@ is set to position ''3’’ when
the seventh program on the tape is being heard, and if the
Fast Forward Lever@ is pressed, the tape will automatically
stop at position (B) (interval) in Fig. 10 and play will then
begin. if the Rewind Lever @is pressed, the tape will be
rewound to position (A) (interval) and play will then begin
—i.e. if you want to rewind three programs, set the Memory
|
~~
|