Panasonic RX-C45LS - Page 7

RX-C45LS = RX-C45LS
DISASSEMBLY INSTRUCTIONS
Slider
(A)
<RADI
When removing the slider, the spring and
steel ball will go out. il
Fig. 13
m@ TO REMOVE CASSETTE PANEL
@Remove the cassette panel in the direction of arrow.
Fig.
3
(H)
(1)
Catch
Eject Button
Screw Driver
Fig. 15
Shown in Fig —
1~3 Front Cabinet
Push the eject button
Dial Chassis *1
R/P HEAD
7
a
=< FT
1
Pull out the dial chassis
Start Point
10 1~6, 8~12
1~14
Power
Source
Circuit
|
Push
the
catch
in
the
direction
of
arrow
and
remove
aa
M
|
Volume
Knob
Board
the
circuit
board
|)
|
Equalizer
Knob
(E) Fig. 5
6 1~6, 16 EXT MIC
Po
1~8,15 Handle Push the catch in the direction of arrow © and remove
the handle in the direction of arrow @
Equalizer and Volume | Push the catch and remove the knob.
Lee ed
Function and Band KON e505 Sean seed Veg yard Mn ae de wiveenc pees (K)x2
| te | 0 Speaker Cabinet
7 1~3,17
R/P HEAD]
|
> FY
ae
Slider Chassis Remove the bracket in the direction of arrow.
*1. To reassemble the dial chassis, note the following.
1) Set the equalizer and volume knob at the position as shown in fig. 5.
2) Set the tuning capacitor to maximum cpacity. (Turn to fully counter-clockwise.)
3) Set the dial pointer to start point as shown in fig. 5.
4) Hang the counter belt.
*2. Press this Part of the Shield Plate to put the Printed Circuit into the Rear Cabinet as shown in Fig. 14.
(3
Fig. 6 Fig. 10 Fig. 11