Panasonic RX-DS28

Listening to radio broadcasts
Ea
toJprog
d
Al
CUA
pegenmed
seene
es
Make sure you have completed the procedure for “Presetting radio
broadcasts” (on page 8).
Press BAND to select “FM” or “AM”.
Every time you press the button: FM +> AM
Press TUNE MODE to display the preset indicator.
The unit is set to the preset tuning mode.
(Gua) = 3 Press -F4 or +> to select the preset channel.
U hA
if
4 Adjust the volume.
cO K || ate to beke ak iih hao | A
= TE ac? Geen aarne] wd confine)
Press BAND to select “FM” or “AM”,
Every time you press the button: FM e AM
Listening operations ie
Press TUNE MODE to clear the preset indicator.
The unit is set to the manual tuning mode.
Press -A44 or +> to tune in the station.
Adjust the volume.
Automatic tuning:
This is a simple way of tuning in stations that have not been preset.
Keep -Atd or +> depressed, and release it when the frequency
display starts to change. A station with good reception is automatically
selected and the selection process then stops.
To stop automatic tuning, press -Fd or +4 again.
Automatic tuning may stop without a station having been tuned in
when interference is encountered on neighbouring airwaves. In such
eh a case, tune in a station by tapping -Atd or +1,
STEREO
Adjusting the antennas
For FM reception:
Pull out the telescopic antenna and adjust its length and angle for
optimum reception.
For AM reception:
Turn the unit in the direction which gives the best results.
Reference
Radio broadcasts may be hard to receive in a moving vehicle or in a
building because the signal may be weakened. In such cases, use the
unit near a window.
When there is a lot of noise in an FM stereo
broadcast D]
Reduce the interference by setting the sound to monaural.
Example:
When an FM stereo program is being received;
Press FM MODE/BP.
j Li. “(MONO)’ is displayed.
CD PLA = pray’
To return to stereo reception, repeat the same procedure and turn off
the display.