Panasonic RX-E300 - Caution for AC Mains Lead; Before Use; Fuse Replacement

Caution
for
AC mains
lead
(For
United Kingdom)
("EB" area
code model only)
For
your safety, please
read the
following
text
care-
fully.
This
appliance Is supplied
with
a
moulded
three
pin
mains
plug
for
your safety
and convenience.
A 5-ampere fuse is fitted
in this plug.
Should the
fuse need to be replaced
please ensure
that
the replacement fuse has
a rating of
5-ampere and
that
it is approved
by
ASIA
or BSI to BS1
362.
Check for the
ASTA mark
<^
or the
BSI mark
^
on
the body of the
fuse.
If
the plug contains
a removable fuse
cover
you must
ensure
that rt is refitted when the
fuse Is replaced.
If you lose the fuse cover
the plug
must
not be
used
until a
replacement
cover is obtained.
A
replacement fuse
cover can be purchased
from your
local
dealer.
CAUTION!
IF THE
FITTED MOULDED PLUG
IS UNSUIT-
ABLE
FOR THE SOCKET OUTLET
IN YOUR
HOME
THEN
THE
FUSE SHOULD
BE RE-
MOVED
AND THE PLUG
CUT OFF AND
DIS-
POSED
OF SAFELY.
THERE
!S A DANGER OF SEVERE
ELECTRI-
CAL SHOCK
IF THE CUT OFF
PLUG IS IN-
SERTED
INTO ANY 13-AMPERE
SOCKET.
If
a new
plug is
to be fitted please
observe the
wiring
code as shown below.
If In any
doubt please consult
a
qualified electrician.
IMPORTANT
The wires in this
mains
lead
are coloured
in accor-
dance with the following
code:
Blue: Neutral
Brown:
Live
As the colours
of the wires In
the mains lead of this
appliance may not con^spond
with the coloured mark-
ings identifying the terminals
in your plug,
proceed as
follows:
The
wire
which
is coloured BLUE must
be connected
to the terminal in the plug which
is marked with
the
letter N or coloured BLACK.
The
wire
which
is
coloured
BROWN
must
be
con-
nected to the
terminal in
the
plug
which is marked
with
the letter
L or coloured
RED.
Under
no circumstances
should either
of
these
wires
be
connected
to the
earth terminal
of
the
three
pin
plug, marked
with
the letter
E or the Earth Symbol
4^
.
Before
use
Remove
the connector
cover
as follows.
Connector
How
to replace
the fuse
1
.
Remove
the fuse
cover
with a screwdriver.
p\
Fuse cover
2. Replace
the fuse
and attach
the fuse
cover.
Fuse
(5
ampere)