Panasonic RX-ES30 - Power Source Options

Household AC outlet
(AC 120 V, 60 Hz)
AC power cord
(included)
5 eT a
ea
t 4318 x
l Ty
Lo
a SS
ga pasm i E t
s, EH tal yt x] i ae
i AEN tuo E]
2 S
em a |
(R6/LR6, AA, UM-3)
Lı 200
OC Cre
Power Sources
|
Cparcting unl am LS paar A
Connect the included AC power cord to the [AC IN ~] socket of the
unit and your household AC outlet.
Crarciig m on Ey POVE
(Ne? idhep
Before use Ee
Battery installation and removal {J
Place unit on a soft cloth when instailing and removing batteries to
avoid damaging the front panel.
®© Open the battery cover on the rear panel.
@) Instali batteries in the order indicated in the diagram.
Remove batteries by inserting your finger into opening at the bottom
of the unit and pushing out.
When to replace the batteries
When the batteries are weak:
“TÆ” starts to flash and “U01” appears on the display, then the unit
automatically turns itself off.
Be sure to replace all batteries with new ones.
Memony, (Notlinciuded)
What is memory?
Memory is the information which can be programmed into the unit
such as:
¢ Time
* Time programming
« CD programming
e Radio stations
If memory batteries are not used, the memory is cancelled at the fol-
lowing times.
e In electric failures
* When the AC power cord is removed from the AC outlet
* When using batteries as the power source, the AC power cord is
inserted into the unit while disconnected from the AC outlet
Battery installation and removal D3 OG
Lift the negative end of the number 4 battery to remove batteries.
Replacing batteries
e The service life of these batteries is approximately one year. To
preserve the memory, connect the AC power cord to the household
AC outlet before replacing all the memory batteries with new ones.
* When disconnecting the AC power cord, first turn the unit off by
pressing [POWER ¢)/l]. The service life of the memory back-up
batteries is reduced if the AC power cord is disconnected from the
household AC outlet with the power still supplied.
5
RQT4760