2 - 9
VRF SYSTEMS Indoor Unit
2
9. Automatic Flap Control
10. Filter Sign
9. Automatic Flap Control
The flap position can be selected from 5 positions.
Operating mode Flap position
Cooling/Dry F1・F2・F3
Fan F1・F2・F3・F4・F5
Heating F1・F2・F3・F4・F5
① The fl ap moves to the following position automatically when the indoor unit is stopped.
F0 (close): Types K1, K2, T2, U1, Y2
F5: Models other than the above
② The fl ap closes once and moves to the set position when the operating mode is changed.
※ If the flap position cannot be adjusted because of a problem, only the swing operation can be
used. Check the fl ap and fl ap motor.
※ The swing operation can be set for the fl ap.
10. Filter Sign
① When accumulated operating time of the indoor unit reaches the set time, the fi lter sign appears on
the remote controller. Clean the fi lter.
See page 5-10.
② After cleaning the fi lter, press the fi lter button on the remote controller once. The fi lter sign turns off.
F1
F2
F3
F4
F5
F0
SM830232-00欧州向けVRFIndoor201404.indb9SM830232-00欧州向けVRFIndoor201404.indb9 2014/04/0414:25:452014/04/0414:25:45
To Next Page
Loading...
