Panasonic S-36PN1E5

1
1-355
Checking indoor unit addresses
Use the remote controller to check the addresses of the indoor units.
Indicating (marking) the indoor and outdoor unit combination number
Installing the Remote Controller
Precautions for remote controller installation
Indicate (mark) the number after automatic address setting is completed.
Press and hold the
(simple settings mode, “ALL” appears on the remote controller).
Then press the
The indoor unit fan operates only at the selected indoor unit.
Confirm the indoor unit address. (For the system addresses of the
No. 2 outdoor unit, the displayed addresses are 2-1, 2-2)
(For the system addresses of the No. 1 outdoor unit, each time the
button is pressed, the address changes as follows: 1-1, 1-2)
button and select the indoor address.
button and button for 4 seconds or longer
So that the combination of each indoor unit can be easily checked when multiple units are installed, ensure that
the indoor and outdoor unit numbers correspond to the system address number on the outdoor unit control PCB,
and use a magic marker or similar means which cannot be easily removed to indicate the numbers in an easily
visible location on the indoor units (near the indoor unit nameplates).
Example: (Outdoor) 1 – (Indoor) 1, 2
(Outdoor) 2 – (Indoor) 1, 2
(1)
These numbers will be needed for maintenance.
Be sure to indicate them.
(2)
Press on both sides of the remote controller cover
and slide it downward to remove it.
(1)
Insert 2 AAA alkaline batteries.
(Pay attention to the + and – directions.)
(2)
Gently insert one end of an unfolded paper clip
(or a similar object that can fit) into the Reset hole
and press the reset button inside the hole and then
put the cover back on.
(3)
To remove the remote controller, pull it toward you.
Press the button again to return to the normal remote controller mode.
If the remote controller is to be installed onto a wall or
other surface for use, first place the remote controller
in the location where it will be installed and press
(ON / OFF).
Confirm that the “signal-received” sound occurs at the
indoor unit and that the A/C begins operating.
Before mounting the remote controller on the wall, place the unit at the mounting position, then turn on any
fluorescent lamps, press the ON/OFF button, and check that the air conditioner operates correctly.
When using the remote controller to detect the room temperature, observe the following precautions during
installation:
Avoid locations where the remote controller will be exposed to the direct path of air blown from the air
conditioner.
Avoid locations where the remote controller will be exposed to direct sunlight.
Avoid locations where the remote controller will be exposed to direct heat sources.
Installing the batteries
1
2
Fasten the remote control
mount with screws.
Fitting the remote
control in the mount.
Press
Put in
Remote control
mount
Reset hole
Cover
SM830211-07PAC-i.indb355SM830211-07PAC-i.indb355 2013/09/1722:48:122013/09/1722:48:12