Panasonic S-36PN1E5

5-3
5
ON: Blinking: OFF:
Possible cause of malfunction
Activation of
protective
device
Thermistor
fault
EEPROM on indoor unit PCB failure
Protective
device for
compressor is
activated
Protective device for
compressor is activated.
Protective device in outdoor
unit is activated.
Indoor thermistor is either
open or damaged.
Outdoor thermistor is either
open or damaged.
High pressure trouble
Compressor discharge temperature trouble
AC power supply trouble
Outdoor unit fan motor trouble
Compressor overcurrent trouble
HIC trouble
Indoor coil temp. sensor (E1)
Indoor coil temp. sensor (E3)
Indoor suction air (room) temp. sensor (TA)
Indoor discharge air temp. sensor (BL)
Compressor discharge temperature sensor (TD)
Intermediate temperature sensor (C2) in heat exchanger
Outdoor air temperature sensor (TO)
Compressor inlet suction temperature sensor (TS)
Outdoor unit nonvolatile memory (EEPROM) trouble
Primary current CT sensor (current sensor) failure
Sensor failure, Compressor discharge temperature sensor (TD)
disconnected
Primary (input) overcurrent detected
PAM trouble
P05
51PInsufficient gas level detected
P04
P03
P16
P22
Lack of INV compressor wiring, INV compressor actuation failure
(including locked), DCCT failure
Group control error
P29
P31
H31
F01
F03
F10
F11
F04
60FInlet temperature sensor (C1) in heat exchanger
F07
F08
F12
F29
F31
H03
H05
H02
H01
Operation
Preparing
Wired
remote
control
display
Wireless
remote controller
receiver display
Timer
Timer lamp blinking
Timer lamp blinking
Operating and
timer lamp blinking
simultaneously
Operating and
timer lamp blinking
simultaneously
Operating and
heating ready
lamp blinking
altemately
Operating and
timer lamps
blinking alternately
Operating and
timer lamps
blinking alternately
Alarm valve open P13
Timer and heat
ready lamp
blinking
altemately
SM830211-07PAC-i.indb3SM830211-07PAC-i.indb3 2013/09/0710:41:232013/09/0710:41:23