Panasonic S-36PU1E5A

1
1-300
Remote controller setting mode
(1) Press both and buttons on the remote controller for more than 4 seconds together.
(2) Select CODE No. with
(3) Change DATA with
(4) Press
* DATA is memorized in the RCU. (DATA setting will not be changed even when the power is turned off.)
* Make sure to set [Normal] for RCU. CK.
. Finally, press .
/
/ (TIMER) buttons.
( ) buttons.
To set the remote controller main/sub setting or change the sensor, follow the steps below.
CODE
ITEM
ITEM
DATA
RCU. Main/Sub
Clock display
RCU. CK
Room temperature sensor
Sub
24 hours
RCU. CK
Main unit
Main
12 hours (AM/PM)
Normal
RCU
SM830231-00Single欧州.indb300SM830231-00Single欧州.indb300 2014/06/0510:12:372014/06/0510:12:37