Panasonic S-50PY3E - Page 50

50
(5) Select the “Set data” by pressing the or button.
Select one of the Setting Data “YYYY” by pressing the
or button.
Then press the
button.
If you wish to change the selected indoor unit, follow Step (3).
(6) Press the
button to finish.
The “Exit detailed settings and restart?” (Detailed setting-
end) screen appears on the LCD display.
Select “YES” and press the
button.
(Return to normal remote controller display.)
<Procedure of CZ-RTC4>
Stop the system before performing these steps.
(1) Press and hold the
, and buttons
simultaneously for 4 seconds or longer.
(2) If group control is in effect, press the
button to
set. At this time, the fan at the indoor unit begins
and select the address (unit no.) of the indoor unit
operating.
NOTE
If the address setting is not set up correctly, the
“ALL” will be displayed in the “Unit no.”.
(3) Designate the item code “XX” by adjusting the Temperature Setting
/ buttons.
(4) Press the timer time
/ buttons to select the desired setting data.
(5) Press the
button.
(The display stops blinking and remains lit, and setting is completed.)
If you wish to change the selected indoor unit, follow Step (2).
(6) Press the
button to return to normal remote controller display.
Detailed settings
Unit no. Code no. Set data
1-1
Sel.
20:30 (THU)
XX YYYY
[ ] Confirm
Detailed settings
Unit no. Code no. Set data
ALL
Sel. Next
20:30 (THU)
01 0002
Exit detailed settings
and restart?
NOYES
A
°
°
(5)
(6)
(2)
(2)
(4)
(3)
(4)
YYYY
XX
(1)
01_330918_EU_Eng.indb 50 2021/9/9 11:26:57