64
CZ-RTC4 (Timer remote controller)
1. Press and hold the
button and button for 4
seconds or longer (simple settings mode).
2. “ALL” is displayed on the remote controller.
At this time, the indoor unit fan (or all indoor unit fans in the
case of group control) begins operating.
3. If group control is in effect, press the
button and
select the address (unit No.) of the indoor unit to set.
* If unit No. “ALL” is displayed, the same setting will be made
for all indoor units.
4. Press the temperature setting
button to select the
“0E” code.
5. Press the timer time
/
buttons to set the setting
data to “0001”.
6. Press the
button. (The display stops blinking and
remains lit, and setting is completed.)
7. Press the
button to return to normal remote controller
display.
A
°
°
17 6
3
2
5
4
CZ-RTC4
00_341136_2WAY_Eng.indb 64 2022/9/19 9:27:37
To Next Page
Loading...
