The function of this circuitry is to prevent circuitry damage if, for example, the positive and
negative speaker connection wires are
“shorted”, or if speaker systems with an impedance less than the indicated rated impedance of
the amplifier are used.
If this occurs, follow the procedure outlines below:
1. Turn off the power.
2. Determine the cause of the problem and correct it.
3. Turn on the power once again after one minute.
Note :
When the protection circuitry functions, the unit will not operate unless the power is first turned
off and then on again.
6. Connection of the Speaker Cables
- Be sure to connect speaker cables before connecting the AC
power supply cord.
- The load impedance of any speaker used with this unit must be 4 .
- Be sure to connect the cable from the right speaker to the right
terminal and the cable from the left speaker to the left terminal.
1. Strip off the outer covering, and twist the center conductor. Make
sure the bare ends of the wires are not unravelled. (If they are,
twist them tight again.)
2. Insert the wire to the rear panel of the unit and close the lever.
Notes :
- To prevent damage to circuitry, never short-circuit positive (+) and
5
To Next Page
Loading...
