5
RQT9789
Making the connections
Connect the AC power supply cord only after all the
other connections have been made.
1 Connect the AM loop antenna.
Stand the antenna up on its base until it clicks.
2 Connect the FM indoor antenna.
Place the antenna where reception is best.
3 Connect the speakers.
Connect the speaker cables to the terminals of the
same color.
4 Connect the AC power supply cord.
Do not use an AC power supply cord from other
equipment.
Conserving power
The system consumes approximately 0.2 W when it
is in standby mode. Disconnect the power supply if
you do not use the system.
Some settings will be lost after you disconnect the
system. You have to set them again.
Preparing the remote control
Use alkaline or manganese battery.
Install the battery so that the poles (+ and –) align with
those in the remote control.
SC-AKX75P_RQT9789-P.book Page 5 Tuesday, March 12, 2013 11:25 AM
To Next Page
Loading...
Need help?
General
