36
VQT5F80
Speaker installation
option
Consult a qualified building contractor when
attaching the speakers to a wall. Improper
attachment may result in damage to the wall and
speakers and personal injury.
You can attach all of the speakers (except
subwoofer) to a wall.
≥ The wall or pillar on which the speakers are to
be attached should be capable of supporting
10 kg per screw.
1 Drive a screw (not supplied) into the wall.
A At least 30 mm
B ‰ 4.0 mm
C ‰ 7.0 mm to
‰ 9.4 mm
D Wall or pillar
E 5.5 mm to 7.5 mm
2 Fit the speaker securely onto the screw(s)
with the hole(s).
Use the measurements indicated below.
≥ Leave at least 20 mm of space above the
speaker and 10 mm on each side to allow
enough space for fitting the speaker.
CENTER
A 33 mm
B 75 mm
C 200 mm
FRONT, SURROUND
Attach to a wall with the bottom cover.
≥ [BTT885] Before using the speaker cable,
remove it from the stand by pulling it out.
∫ [BTT885]
Reattaching the speaker cable to the stand
1 Remove the front cover.
2 Thread the speaker cable through the stand,
and press the cable into the grooves.
3 Perform step 1 in reverse order to attach the
front cover.
Attaching to a wall
e.g., Front speaker
DO NOT DO
≥ In this position, the
speaker will likely fall if
moved to the left or right.
≥ Move the speaker so
that the screw is in this
position.
Screwing positions on the
wall
SC-BTT885&505EB-VQT5F80_mst.book 36 ページ ２０１４年３月１９日 水曜日 午後４時５２分
To Next Page
Loading...
