Panasonic SC-CH55 - Troubleshooting Guide (continued); When there is a television set nearby; While listening to tapes; While listening to compact disc

Troubleshooting
Guide
conines
When there is a television set nearby
The
picture
disappears
or
The
location
and
orientation
of
the
antenna
are
elf
an
indoor
antenna
is
being
used,
change
to
an
stripes
can
be
seen.
incorrect.
outdoor
antenna.
© Separate the television set from the system.
The wiring at the back of the system is unsuitable. | @Separate the antenna wire of the television set
from the system.
While listening to tapes
of
poor
qualityu,
noisy,
The
Dolby
NR
switch
is
set
in
the
wrong
position.
©Set
it
to
match
the
recording
condition.
scrachy, or unsteady.
The deck section does not The erase-prevention tabs have been removed. eAttach tape to cover the space left by removal of
enter the recording mode. the
The
cassette
holder
The
AC
power
cord
has
disconnected
or
the
@After
re-connecting
the
AC
power
cord,
switch
on
doesn’t
open
by
even
power
interruption
has
taken
place
during
the
the
power
and
then
press
the
eject
button.
pressing
the eject
button.
operation.
While listening to compact disc
The tray does not close The disc is not sitting correctly in the disc tray. @Re-insert the tray.
when a disc is loaded and
the OPEN/CLOSE button
pressed.
The total number of tracks The disc is not sitting correctly in the disc tray. eRe-insert the tray.
and total time are not
displayed when a disc is e disc is loaded upside down Re-load the disc
loaded. The disc does not The disc is dirty. Wipe the disc with a soft cloth.
start
being
played
when
The
disc
is
scratched.
Replace
the
disc
with
a
new
one.
the
play
button
is
pressed.
a
: ;
;
A
certain
part
of
the
disc
The
disc
is
badly
warped.
Skip
the
scratched
part
of
the
disc
(skip
play).
cannot
be
played.
The
disc
used
is
a
non-standard
one.
Replace
the
disc
with
a
different
one.
There is condensation inside the unit. Switch ON the power, then wait for 20 to
30 minutes before using it.
While using the remote control
The system cannot be The batteries are installed in the reverse polarity. @Re-insert the batteries in the correct polarity.
ae with the remote The batteries are worn. Replace the batteries with new batteries.
control.
—58—